Dixie Chopper X2002-50 - Routine Maintenance

', ;,( &+233(5
'
Check
En
g
ine Oil Level
Check
H
y
draulic Oil Level
Check
Tire Pressure
Use oil in accordance 15W40 Synthetic or full synthetic Rear 5-7 psi - 6 preferred
manufacturers recommendations
Front 10-14
p
si
Lube
Deck S
p
indles, Idler Arm
Pivots, Front Wheel Bearings,
(3-5 pumps)
Check engine to Transmission
Chan
g
e
En
g
ine Oil
Check
Batter
y
Fluid Level Belt Tension
(If applicable) 1-1/2" from idler to frame
Lube
Steerin
g
Clean
Donaldson Air Filter End Cap
Levers (DO NOT BLOW OUT WITH COMPRESSED AIR)
Chan
g
e
H
y
draulic Filters
Chan
g
e
Amsoil Filter
Remove Belts and Check
S
p
indle
Bearings, Idlers, and Pulleys
Lube
Front
Clean or Re
p
lace Check
Steerin
g
for Cree
p
Caster Bearings Spark Plugs in the Neutral Position
Check
Front and Rear
Re
p
lace En
g
ine
Tires for Tread Wear Fuel Filter(s)
Chan
g
e
H
y
draulic Drive Oil
DO NOT USE HYDRAULIC OIL, HYTRAN, OR AUTOMATIC TRANSMISSION FLUID.
USE ONLY A HIGH GRADE 10W50,15W40,20W50 MOTOR OIL THAT MEETS THE
MINIMUM VISCOSITY RE
Q
UIREMENTS OF:
89 SUS or BETTER @ 212 DEGREES
FAHRENHEIT.
Routine Maintenance
Daily Checks
Every 50 Hours
Every 100 Hours
Every 250 Hours
Every 500 Hours
or Annually
Every 2000 Hours
Note:
The recommended Hydraulic Drive oil for your Dixie Chopper machine is D/C
Part#60106. We strongly urge that you use this oil in the event that you should need
to refill or add to your hydraulic reservoir. However, if this oil is unavailable to you,
any premium grade 10W40, 15W50, 20W50 synthetic or synthetic blend may be used
P
ROVIDING IT MEETS THE ABOVE REQUIREMENTS.