Dixie Narco HVV 276E - User Manual

To Next Page

M095.x

1 of 6

3330 Dixie-Narco Blvd.

Williston, SC 29853

www.dixienarco.com

M095.0

Energy Star Evaporator Fan Motor Sub-Assembly

276E HVV

06/10/09

Safety Precautions!

• Please read these instructions in their entirety before proceeding.

• Ensure that the Electrical Power is disconnected from the Vending Machine by removing Vending

Machine Power Cord from the wall outlet.

• Remember use caution working with the Refrigeration Unit parts. These parts may have sharp edges and

corners.

• Failure to comply with these instructions could result in injury or electrical shock, which can be serious

or fatal.

Models affected: All Pepsi HVV 276E-Model Venders

Produced Beginning Production Run 6757DZ and higher.

Reason: To Provide Step-by-Step Instructions for the

removal of the current Evaporator Fan Shroud Assembly

and installation of the new Energy Star Evaporator Fan

Shroud Assembly. This kit is designed to be installed in

venders with factory installed Environmental Control Kits

and SBC (Single Board Controller) E Model electronics.

Additional information for the Environmental Control

Assembly (631,004,00x.x4) can be obtained from

Instruction E013.x or contact your Dixie-Narco

Representative or the Technical Service Department.

Need help?

Do you have a question about the Dixie Narco HVV 276E and is the answer not in the manual?

Summary

Essential safety guidelines to follow before and during the installation process to prevent injury or electrical shock.

Lists all parts included in the kit and specifies the required tools for the installation procedure.

Detailed, step-by-step instructions for removing the old assembly and installing the new Energy Star Evaporator Fan Motor.

General