dji AGRAS MG-1 - Installation Guide; Mounting Landing Gear

12
©
2016 DJI All Rights Reserved.
AGRAS MG-1
Quick Start Guide
Trytokeeptheaircraftinsidetheoptimaltransmissionrange.Ifthesignalisweak,adjusttheantennasorythe
aircraftcloser.
 Avoidusingwirelessdevicesthatusethesamefrequencybandsastheremotecontroller.
Getting Ready for Takeo
1. Placetheaircraftonanopen,atgroundwiththeAircraftStatusIndicatorfacingtowardsyou.
2. Unfoldpropellersandcheckthattheyareunfoldedandmountedontothemotorssecurely.Unfoldframearms
andtightenarmsleevesrmly.(RefertoPage6forhowtounfoldtheframearms.)
3. Toggle the Flight Mode Switch to P-mode.
4. Toggle the Operation Mode Switch to Manual mode.
5. Powerontheremotecontroller.
6. ConnectthebatterytothecommunicationportandthentheXT90port.
Calibrating the Compass
1. Flip theFlightMode Switchback-and-forthat least6times,untiltheAircraftStatus Indicatorbecomes
solid blue.
2. Holdthe aircraftuprightandrotateit360 degreesalong thecentralaxis,untilthe AircraftStatus Indicator
changesfromsolidbluetosolidgreen.
3. Holdtheaircraftwithitsnosefacingupandrotate360degreesalongthecentralaxis.
4. TheAircraftStatusIndicatorshowsthecurrentightmodewhencalibrationiscomplete.IftheAircraftStatus
Indicatorbecomesblinkingred,repeatthestepsabovetorecalibratethecompass.
OptimalTransmissionRange
P-mode M-mode