dji AGRAS MG-1 - Unfolding Frame Arms

14
©
2016 DJI All Rights Reserved.
AGRAS MG-1
Quick Start Guide
Smart Operation
Theaircraftwilltravel alongpre-designatedsquarezig zagrouteaftertheturningPointsAandB havebeen
recorded.Thealtitudedifferencebetweenthe aircraftand vegetationismaintained underoptimalworking
conditions.The aircraftwill spray liquidautomaticallywhile ying alongtherouteandstop spraying liquidwhile
hoveringattheturningpoints.Thelengthofthedottedlines,whicharecalledOperationGaps,canbeadjusted
inthe PCAssistant.It isrecommendedtoyinSmart OperationModewhen thesprayareaislarge andina
rectangular shape.
EnsurethatFlightMode Switch ontheremotecontrolleristoggledtothe “P”positionanda strongGPS signal
ispresent.Inaddition,ensurethattheOperationModeSwitchonthe remotecontrolleris toggledtothe“M”
position.
1. Record Points A and B in Order
Flythe aircraftto the startingpoint,depicted as PointA(B), hover,andthenpress
ButtonA(B)ontheremotecontroller.ThePointA(B)LEDontheSprayingStatusPanel
willbecome solidgreenandtheAircraftStatusIndicator willblinkred(green)afterthe
starting points have been recorded.
UpdatePointBbyflyingtheaircrafttoanewpositionandrecordthisposition.NotethatifaPointAhasbeen
updated,thenPointBisalsorequiredtobeupdatedaccordingly.
Itisrecommendedto keepthe directionofPointA toB paralleltoone sideofthe rectangularsprayareafor
optimaleffect.
Theoptimaldetectionrangefor thesprayingdistanceisbetween 1.5to7meters.Always operatetheaircraftabove
vegetationwithinthisrangewhileadjustingaircraftaltitude.
Idealsprayingdistanceshouldfallwithintheworkingrange(2-3.5meters)foraltitudestabilization.
RefertotheUserManualformoreinformationabouttheworkingconditionsoftheAltitudeStabilizationSystem.
2. Select the Route
PressBackLeftButtonC1orBackRightButtonC2ontheremotecontrollertoselectthe
operatingpattern.PressBackLeftButtonC1forRouteLandBackLeftButtonC2forRoute
R.TheOrientationLEDontheSprayingStatusPanelwillblinktoshowthattheselectionhas
beenmade.ThedefaultroutepatternisRouteR,ifnoselectionhasbeenmade.
3. Adjust the Aircraft Altitude
Adjustthe aircraftaltitude tothedesiredaltitudeby usingthethrottlestickbeforeenteringSmart Operation
Mode,andtheAltitudeStabilizationSystemwillstartworkingautomaticallyandmaintainthesprayingdistance
betweentheaircraftandthevegetation.
Instructions:
a. Flytheaircraftabovethe vegetationandadjust thesprayingdistancebetween the
aircraftandthevegetation.
b. ConrmthedesiredsprayingdistancebyobservingtheHeightLEDsontheSpraying
Status Panel.
RouteL RouteR Legends
- - - - Operation Gap
●
Turning Point
A
B
A
B R1
R2
L1
L2 R3
R4
L3
L4 R5
…………
R6
L5
L6