AGRAS T50/T25
Unmanned Aircraft Flight Manual
16
©
2023 DJI All Rights Reserved.
17. Left Dial
Turn to adjust the spray rate in Manual
operation mode.
18. Spray/Spread Button
Press to start or stop spraying/spreading
in Manual operation mode.
19. Flight Mode Switch
The three positions of the switch
correspond to: N-mode (Normal), S-mode
(Attitude), and F-mode (Normal).
20. Internal RC Antennas
Relays aircraft control and image
transmission signals. Do not block
the internal RC antennas during use.
Otherwise the signals may be affected.
21. microSD Card Slot
Slot to insert a microSD card.
22. USB-A Port
For connecting devices such as the RTK
Dongle. When it is connected to the
intelligent charger or multifunctional
inverter generator, users can view the
device status information in DJI Agras.
23. HDMI Port
The output of the HDMI signal to an
external monitor.
24. USB-C Port
For charging the remote controller or
connect to a computer to update firmware
and export logs via the DJI Assistant 2
software.
25. FPV/Map Switch Button
In Operation View in DJI Agras, press to
switch between FPV and Map View.
26. Right Dial
Turn to adjust the tilt of the FPV camera.
27. Scroll Wheel (reserved)
28. Handle
29. Speaker
30. Air Vent
For heat dissipation. Do not block the air
vent during use.
31. Reserved Mounting Holes
32. Button C1
In Route (A-B) operation mode, press to
record Point A.
In Manual Plus operation mode, press to
steer the aircraft left.
33. Button C2
In Route (A-B) operation mode, press to
record Point B.
In Manual Plus operation mode, press to
steer the aircraft right.
34. Rear Cover
35. Battery Release Button
36. Battery Compartment
For installing the WB37 Intelligent Battery.
37. Rear Cover Release Button
38. Alarm
39. Air Intake
For heat dissipation. Do not block the air
intake during use.
40. Dongle Compartment
The USB-C connector in the compartment
is used to connect the DJI Cellular Dongle.
41. Strap Bracket