dji AGRAS T50

AGRAS T50/T25
Unmanned Aircraft Flight Manual
68
©
2023 DJI All Rights Reserved.
Reassembly
Follow the steps of disassembly in reverse order for reassembly.
Propellers
Disassembly
1. Remove the two M5×15 propeller blade screws using a proper hex key.
2. Remove the propeller adapter, the two washers above and under each propeller blade.
Reassembly
Identify the CW or CCW marks on the propeller blades and motors. Make sure to assemble the
parts with the same mark. T50 users can identify the upper (U) and lower (L) propeller blades
with the corresponding letter at the end of the model number on each propeller.
1. Place the one washer onto one of the mounting hole on the motor. Place the propeller
blade and then one washer.
2. Follow the same steps for the other mounting hole on the motor.
3. Place the propeller adapter on the top.
4. Insert the two M5×15 screws to the mounting holes and tighten to secure the propeller
blades.
Sprinklers
Disassembly
1. Rotate and remove the screw and cover at the bottom of the sprinkler. Remove the
centrifugal disk module.
2. Separate the upper and lower disks.
3. Remove the washer on the lower disk.
M5×15 Screws
Washers