dji AGRAS T50 - Page 58

AGRAS T50/T25
Unmanned Aircraft Flight Manual
56
©
2023 DJI All Rights Reserved.
4. Select the Route
After Point A and B are recorded, the app produces Route R or Route R’ by default. Tap this
button to switch to Route L or Route L’.
5. Performing an Operation
Tap
and move the slider to start the operation.
If the completed routes are greater than or equal to three lines (including the route
from Point A to Point B), users can save the routes as a field and use it again.
Make sure to maintain a visual line of sight (VLOS) with your aircraft during the
operation.
Make sure that there is a strong GNSS signal during operation. Otherwise, the
operation may not be completed successfully.
Users cannot control the aircraft heading via the control stick during the operation.
When using the control sticks to control the aircraft in A-B Route operation mode,
the aircraft automatically switches to Manual operation mode, completes the
corresponding flight behavior, and then hovers. To resume the operation, tap
Resume onscreen. The aircraft will resume flying along the operation route. Refer to
Operation Resumption for more information.
A
B
A
B R1
R2
L1
L2 R3
R4
L3
L4 R5
…………
R6
L5
L6
Route L
Route R
A
B
A
B
R1’
R2’
L1’
L2’
R3’
R4’
L3’
L4’
R5’
…………
R6’
L5’
L6’
Route L
’
Route R
’
Legend
- - - - Route Spacing
Turning Point