dji Cendence - Product Profile; Introduction; In the Box

4
Charge the Battery
Using IN2CH Charging Hub
Charging Time: 1 hour and 30 min
* DJI approved
charger
When charging is complete, the display on the remote controller will show 100%.
Prepare the Remote Controller
Mounting the Monitor and Remote Controller’s Batteries
It’s the same to mount the Monitor and Remote Controller’s Batteries.
Put the battery into the Battery Slot, then slide it to the end until you hear a click.
Press the Battery Release Button before removing the battery.
Press the Battery Level Button once to check the battery level.
Mounting the Monitor to the Remote Controller
Ensure that Part B is
unlocked. Install Part
B into Part A.
Lock the Mounting
Bracket.
Use a coin to adjust the
tightness of the pitch axis.
Note:Products don't match charger to sales, batteries can be disassembled to recharge,
battery interface can only be DJI charger to match.