dji Force Pro - Connectivity and Settings; Linking Procedures; Main UI and System Settings

5
5. Follow Mode
: Free mode.
: Follow mode.
: FPV mode.
: Recenter mode.
Select Free mode when using the Force Pro.
6. Working Battery Number
: Shows the number of batteries currently in use by Ronin 2. Ronin 2
can operate with one or two batteries.
7. Battery Level
: Displays the current battery level of Ronin 2.
8. Remote Controller Signal Strength
: Displays the remote controller signal strength.
9. Calibration Notice
: Compass calibration is required.
10. Force Pro Battery Level
: Displays the current battery level of the Force Pro.
11. Axes Control Speed Display
Displays the control speed for the three axes.
Linking
The Force Pro supports both wireless and wired connections. Linking is
required when using a wireless connection:
1. Go to the gimbal settings page on the Force Pro and go to “Settings->
General-> Linking;”
2. Press and hold the link button on the DJI Pro Wireless Receiver for two
seconds to initiate the linking procedure.
Using the DJI Pro Wireless Receiver is recommended for optimal performance.
You can also connect a Force Pro to Ronin 2 using Ronin 2's linking procedures.
For the wired connection, connect the DC OUT port on the Force Pro to Ronin
2 using Ronin 2 CAN Bus Control Cable (30 m, sold separately).
Settings
These settings are based on using the Force Pro with Ronin 2.
Main UI Settings
0 M
15
0 M 0 M
10
50%
12
0º
2
60%
50
Tilt
Force
Gimbal
Pan
Roll
RONIN
1. GPS Signal Strength
: Shows the current GPS signal strength.
2. Mounting Modes (If supported)
: Handheld mode.
: Car Mount mode.
: Aerial mode.
: Tripod mode.
3. Pan Lock Mode
: Pan motor follow off.
4. Motor Pause
: Powers off motors.