dji Force Pro - Force Pro Specific Settings; Basic, Custom, and More Settings

6
Force Pro Settings
10
0
15
0
Force
Basic
More
Custom
Deadband
Smoothing
Left
Right
Pan
12
0º
2
60%
Speed
Control
Ronin
Customize C1
Motor Kill
Customize C2
Mode
Force
More
12
0º
2
60%
Custom
Basic
Switch
Restore Force Setup
Restore
About
Calibrate
Compass
Force
Custom
12
0º
2
60%
More
Basic
Access Log File
Language
English
Basic
The Deadband, Smoothing, and Endpoints settings for the pan, roll, and tilt
axes can be independently adjusted. The default endpoint settings for pan axis
are set to 180°, which means there is no endpoint for the pan axis, allowing it to
rotate 360° continuouly.
Custom
Customized functions for the C1 and C2 buttons: Includes Pause, Recenter,
Ronin 2 Pause, and Control mode options.
Control Mode: Includes Speed and Position Control modes.
In Speed mode, turn the Speed Control knob to adjust the movement ratio
between the gimbal and Force Pro. Increase the Smoothing to make the
gimbal’s translated movement smoother and slower. Adjust the Deadband to
adjust the gimbal’s response sensitivity.
In Position mode, the movement ratio between the gimbal and Force Pro
remains 1:1. Turn the Speed Control knob to adjust the gimbal’s response
sensitivity. In Position mode, the Speed Control knob is the only factor that will
affect the gimbal movement.
Restore force setup: Restores the Force Pro to its default settings.
More
Access log le: Internal storage is built into the Force Pro for recording data. If
the gimbal is acting abnormally, contact DJI Support. If the provided solutions
are not successful, DJI Support will request log les for further analysis. Access
log les only when instructed to do so by a DJI support specialist.
Compass Calibration: If errors occur with the compass, select “Calibrate” and
then follow the onscreen instructions to calibrate the compass.
Language: Languages can be switched between English and Chinese.
About: Displays the SN number and the rmware version of your Force Pro.