dji FPV Remote Controller 3 User Manual

DJI FPV
Remote Controller 3 User Manual
16
©
2024DJI All Rights Reserved
Setting the Custom Mode to Manual Mode
After adjusting the throttle sticks, Manual mode can be enabled in the goggles:
1. Power on the aircraft, goggles, and remote controller. Make sure all the devices are linked.
2. Press the 5D button and open the menu. Go to Settings > Control > Remote Controller >
Button Customization > Custom Mode, and Set to Manual Mode.
• When using Manual mode for the first time, the maximum attitude of the aircraft
will be restricted. After the pilot is familiar with ying in Manual mode, the attitude
restriction can be disabled in the goggles, and the Gain and Expo can be adjusted
based on actual needs.
Flying in Manual Mode
Starting the Motors
Keep the throttle stick in the lowest position and press the start/stop button twice to start the
motors.
Throttle Stick
+
Push the throttle stick up slowly to take o.
Stopping the Motors
When the aircraft has landed, press the start/stop button twice to stop the motors.
• When the aircraft is in Manual mode, press the ight pause/RTH button once to make
the aircraft brake and hover in place. The aircraft attitude returns to level and the
ight mode automatically switches to Normal mode.
• Land on at ground to avoid the aircraft rolling over during landing.
• It is recommended to switch to Normal mode before landing to ensure ight safety.
Training in Flight Simulators
In Manual mode, the control sticks are used to directly control the throttle and attitude of the
aircraft. The aircraft has no ight assistance functions such as automatic stabilization and can
reach any attitude.

dji FPV Remote Controller 3 Specifications

General

Brand	dji
Model	FPV Remote Controller 3
Category	Remote Control
Language	English