©
2017 DJI All Rights Reserved.
63
INSPIRE 2
User Manual
Stopping the Motors
There are two methods to stop the motors.
Method 1: When Inspire 2 has landed, push the left stick down
, then conduct the same CSC that
was used to start the motors, as described above
. Motors will stop immediately. Release both
sticks once motors stop.
Method 2: When the aircraft has landed, push and hold the left stick down. The motors will stop
after three seconds.
Do not perform CSC when aircraft is in midair, otherwise the motors will be stopped.
6WRSWKH0RWRU0LGÁLJKW
Pull the left stick to the bottom inside corners and press the RTH button at the same time.
Only stop
WKHPRWRUVPLGñLJKWLQHPHUJHQF\VLWXDWLRQVZKHQGRLQJVRFDQUHGXFHWKHULVNRIGDPDJHRU
LQMXU\
OR
Method 1 Method 2
Flight Test
Takeoff/Landing Procedures
1MBDFUIFBJSDSBGUJOBOPQFOnBUBSFBXJUIUIFCBUUFSZMFWFMJOEJDBUPSTGBDJOHUPXBSETZPV
2. Turn on the remote controller and your mobile device, then turn on the Intelligent Flight Battery.
3. Launch the DJI GO 4 app and enter the Camera page.
4. Wait until the Aircraft Indicators blink green. This means the Home Point is recorded and it is now
TBGFUPnZ*GUIFZnBTIZFMMPXUIF)PNF1PJOUIBTOPUCFFOSFDPSEFE
5. Push the left stick up slowly to take off or use Auto Takeoff.
6. Shoot photos and videos using the DJI GO 4 app.
7. To land, hover over a level surface and gently pull down on the left stick to descend.
8. After landing, execute the CSC command or hold the left stick at its lowest position until the mo-
tors stop.
5VSOPGGUIF*OUFMMJHFOU'MJHIU#BUUFSZmSTUUIFOUIF3FNPUF$POUSPMMFS
Please check that CSC is activated inside DJI GO 4 app, then the user can stop the
aircraft mid-air.
To Next Page
Loading...
Need help?
General
