EasyManuals Logo

dji MATRICE 200 series Quick Start Guide

dji MATRICE 200 series
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
proximity to the antenna shall not be less than 20cm during normal operation.
For Remote Controller (model GL900A),SAR tests are conducted using standard operating positions
accepted by the FCC/ ISEDC with the device transmitting at its highest certified power level in all
tested frequency bands, although the SAR is determined at the highest certified power level, the actual
SAR level of the device while operating can be well below the maximum value. Before a new model is
a available for sale to the public, it must be tested and certified to the FCC/ ISEDC that it does not
exceed the exposure limit established by the FCC/ ISEDC, Tests for each product are performed in
positions and locations as required by the FCC/ ISEDC. For Handheld operation, this device has been
tested and meets the FCC/ ISEDC RF exposure guidelines when used with an accessory designated for
this product or when used with an acces sory that contains no metal.
For body worn operation, Remote Controller (model GL900A) has been tested and meets the FCC/
ISEDC RF exposure guidelines when used with an accessory designated for this product or when used
with an accessory that Contains no metal and that positions the handset a minimum of 10 mm from the
body.
Non-compliance with the above restrictions may result in violation of RF exposure guidelines.
ISEDC Radiation Exposure Statement:
L’aéronef est conforme aux limites d’exposition aux rayonnements de la FCC/ ISEDC établies pour un
environnement non contrôlé. Afin d'éviter tout risque de dépassement des limites d'exposition aux
fréquences radioélectriques imposées par la FCC/ ISEDC, la proximité humaine de l'antenne ne doit pas
être inférieure à 20 cm en fonctionnement normal.
Pour le contrôleur à distance (modèle GL900A), les tests SAR sont effectués à l'aide de positions de
fonctionnement standard acceptées par la FCC/ ISEDC, l'appareil transmettant à son niveau de
puissance certifié le plus élevé dans toutes les bandes de fréquences testées, bien que le SAR soit
déterminé au niveau de puissance certifié Le niveau de DAS de l'appareil en cours d'utilisation peut être
bien inférieur à la valeur maximale. Avant qu'un nouveau modèle ne soit disponible à la vente au public,
il doit être testé et certifié par la FCC/ ISEDC qu'il ne dépasse pas la limite d'exposition fixée par la
ISEDC. Les tests de chaque produit sont effectués à des emplacements et à des emplacements requis par
la ISEDC. . Pour le fonctionnement en mode portable, cet appareil a été testé et respecte les directives
d'exposition RF de la FCC/ ISEDC lorsqu'il est utilisé avec un accessoire conçu pour ce produit ou avec
un accessoire ne contenant pas de métal.
Pour une utilisation sur le corps, la télécommande (modèle GL900A) a été testée et répond aux

Other manuals for dji MATRICE 200 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the dji MATRICE 200 series and is the answer not in the manual?

dji MATRICE 200 series Specifications

General IconGeneral
Max Takeoff Weight6.14 kg
Ingress Protection RatingIP43
Satellite SystemsGPS/GLONASS
Max Flight Time38 minutes
Hovering AccuracyVertical: ±0.5 m, Horizontal: ±1.5 m
Diagonal Size650 mm
Charging Temperature Range5°C to 40°C
Operating Temperature Range-4°F to 113°F (-20°C to 45°C)

Related product manuals