dji MATRICE 200 series Quick Start Guide

5
EN
Using the Remote Controller
The Stick Mode is set to Mode 2 by default. In Mode 2, the left stick controls the aircraft’s elevation and heading, and the
right stick controls the aircraft’s forward, backward, and lateral movements. To adjust the FPV camera, press and hold the C2
Button and rotate the left dial.
Left Stick Right Stick FPV Camera
Forward
UP
Down
Turn Left Turn Right
Backward
For more information about how to connect and use the remote controller, please refer to the user manual.
You can change the stick mode and customize the C1-C4 and BA-BH buttons’ functions in the DJI Pilot app.
4. Preparing the Aircraft
Unfolding the D-RTK Antennas (for M210 RTK V2 only)
Unfold the D-RTK antennas and then turn the knob tightly in the direction indicated by the lock icon .
For the aircraft to take off, the D-RTK antennas must be fully unfolded and securely locked.
Installing the Landing Gears Unfolding the Aircraft
Unfold the frame arm, slide the arm lock to the end of the frame
arm, then rotate it about 90° until the silver line lies within the
range of the icon.
Left
Right
2
1
1
3
2

dji MATRICE 200 series Specifications

General

Max Takeoff Weight	6.14 kg
Ingress Protection Rating	IP43
Satellite Systems	GPS/GLONASS
Max Flight Time	38 minutes
Hovering Accuracy	Vertical: ±0.5 m, Horizontal: ±1.5 m
Diagonal Size	650 mm
Charging Temperature Range	5°C to 40°C
Operating Temperature Range	-4°F to 113°F (-20°C to 45°C)