4
EN
Using Matrice 200 V2
1. Downloading the DJI Pilot App
DJI Pilot App
Search for DJI Pilot in Google Play Store or scan the QR code to download the app onto
your mobile device.
First-time activation requires your DJI account and an internet connection.
DJI Pilot supports Android 5.0 or later.
If using a DJI CRYSTALSKY
TM
Monitor, it is recommended to use the built-in DJI Pilot app.
2. Charging the Batteries
Press the release button and open the corresponding charging port cover.
Insert the Intelligent Flight Battery into the charging port to begin charging.
Be sure to press the release button when removing fully charged batteries.
When charging is complete, the LED lights on the Intelligent Flight Battery will turn off, and the LED on the Charging Hub will turn solid green.
When charging is complete, the display on the remote controller will show 100%.
The Charging Hub will sound an alert when the battery has been fully charged. The alert can be turned on or off by toggling the switch under the
hub.
Install the battery into the aircraft and power on. If a low battery temperature is detected, the battery will automatically heat up to maintain a
temperature between 16° and 20° C.
Ensure two Intelligent Flight Batteries are charged and discharged simultaneously to prolong their service life and for a better ight experience.
Using the IN2CH Charging Hub, charging time
is approximately
TB55: 2 hours and 24 min (two batteries)*
Charging Time:
2 hours*
Using the WCH2 Charging Hub,
charging time is approximately
1 hour and 11 min (one battery)*
* Provided charger.
The battery must be fully charged
before using it for the rst time.
Power Outlet
100~240 V
(50Hz/60Hz)
A
2
1
A
B
B
B
Press the Battery Release Button before removing the battery.
Press the Battery Level Button once to check the battery level.
3. Preparing the Remote Controller
Put the battery into the Battery Slot, then slide it to the end
until you hear a click.
Mounting the Remote Controller Battery
Internet
Low
High
To Next Page
Loading...
