dji Matrice 200 V2 - Manual Landing

7
EN
Mounting the Intelligent Flight Batteries
Insert a pair of batteries.
Press once to check the battery level.
Press again and hold until the batteries turn on or off.
Only use battery slot B when using one battery to supply power. In this case, the aircraft can only be powered on, but cannot take off.
If for any reason only one battery is available during ight, land the aircraft immediately and replace the batteries as soon as possible.
Make sure to press the Battery Removal button when removing the battery.
Make sure to use the included TB55 batteries. DO NOT use any other type of batteries.
Low
High
A
B
5. Flight
If using a CrystalSky Monitor, after the monitor is powered on, wait for a pop-up window that asks for a selection of USB device use, and then
select “DJI Pilot”. Otherwise, the app cannot be connected to the remote controller.
Always set an appropriate RTH altitude before takeoff. Refer to the Disclaimer and Safety Guidelines for more details.
Ready to Go (GPS)
Before taking off, ensure that the Aircraft Status Bar in the
DJI Pilot app reads ‘Ready to Go (GPS)’ or ‘Ready to Go
(Vision)’ if ying indoors.
Toggle the Flight
Mode switch to
P-mode, the safest
ight mode.
Power on the remote controller,
and aircraft.
Launch the DJI
Pilot app.
DJI Pilot
App
Learn more:
http://ysafe.dji.com/no-y
It is important to understand basic ight guidelines for the safety of both
you and those around you.
Refer to the Disclaimer and Safety Guidelines for more information.
GEO Zones
Manual Takeoff
Combination Stick Command to start/stop the motors Left stick up
(slowly) to take off
OR
Return-to-Home (RC)
Press and hold to initiate the RTH procedure. Press again to cancel.
Manual Landing
Pull left stick down (slowly)
until you touch the ground.
Hold for a few seconds to
stop the motors.
To stop the motors mid-flight, press
the RTH button while simultaneously
pulling the left stick to the bottom inner
corner. Stop motors mid-flight will
cause the aircraft to crash. The motor
can only be stopped mid-ight when
the flight controller detects critical
error.
Rotating propellers can be dangerous. DO NOT start the motors in narrow spaces or
when there are people nearby.
Always keep your hands on the remote controller so long as the motor is still spinning.
After landing, power off the aircraft before turning off the remote controller.