dji MAVIC AIR - SmartCapture Gesture Control

22
©
2018 DJI All Rights Reserved.
Mavic Air
User Manual
Exiting ActiveTrack
Tap the stop icon button on the screen or toggle the Flight Mode switch to S-mode on the remote
controller to exit ActiveTrack. After exiting ActiveTrack, the aircraft will hover in place, at which point you
may choose to y manually, track another subject, or return to home.
SmartCapture
Deep learning gesture recognition allows you to take selfies, record videos, and control the aircraft
using simple hand gestures. The Mavic Air features brand new modes like GestureLaunch, Follow, and
GestureLand. (Note: Aircraft rmware v1.0.1.0 or higher is required to use SmartCapture.)
Activating FaceAware and PalmControl
To use SmartCapture rst activate FaceAware and PalmControl:
1. Tap in the DJI GO 4 app and select SmartCapture. When FaceAware has activated the aircraft will
beep twice and the Front LEDs will blink red slowly.
2. Next, use one of the following two methods to activate PalmControl:
a. GestureLaunch: If the aircraft is on the ground you can use GestureLaunch to command the
aircraft to take o and activate PalmControl. Stand at a distance of 6.6 to 9.8 ft (2 to 3 m) in front
of the aircraft with your palm in front of the aircraft’s nose. Keep your palm open and your ngers
close together. After about two seconds the aircraft will take off automatically and hover at a
height of 3.9 ft (1.2 m). The Front LEDs will blink green slowly to indicate that PalmControl has
been activated.
DO NOT use ActiveTrack in areas with people, animals, small or fine objects (e.g. tree
branches or power lines), or transparent objects (e.g. glass or water).
Stay clear of obstacles near the ight path, especially obstacles to the left and right of the
aircraft.
Operate the aircraft manually (press the Flight Pause button or toggle the Flight Mode switch
to S-mode on the remote controller) or tap in DJI GO 4 in an emergency.
Be extra vigilant when using ActiveTrack in any of the following situations:
a. The tracked subject is not moving on a level plane.
b. The tracked subject changes shape drastically while moving.
c. The tracked subject could be out of sight for a long time.
d. The tracked subject is moving on a snowy surface.
e. The tracked subject has a similar color or pattern to its surrounding environment.
f. Available light is too low (< 300 lux) or too high (> 10,000 lux).
You must follow local privacy laws and regulations when using ActiveTrack.
1.2m