dji MAVIC AIR - Battery Management; Battery Features and Charging

28
©
2018 DJI All Rights Reserved.
Mavic Air
User Manual
Intelligent Flight Battery
The Mavic Air Intelligent Flight Battery is an 11.55 V, 2375 mAh battery with smart charging/discharging
functionality. It should only be charged using an appropriate DJI approved AC power adapter.
Battery Features
1. Battery Level Display: The LED indicators display the current battery level.
2. Auto-Discharging Function: To prevent swelling, the battery automatically discharges to below
65% of the maximum charge when it is idle for more than 10 days. It takes approximately one day
to discharge the battery to 65%. It is normal to feel moderate heat being emitted from the battery
during the discharging process.
3. Balanced Charging: The voltages of the battery cells are automatically balanced during charging.
4. Overcharge Protection: Charging automatically stops when the battery is fully charged.
5. Temperature Detection: The battery will only charge when the temperature is between 41° and 104° F
(5° and 40° C).
6. Overcurrent Protection: The battery stops charging if an excessive current is detected.
7. Overdischarge Protection: Discharging stops automatically to prevent excessive discharge.
8. Short Circuit Protection: The power supply is cut automatically if a short circuit is detected.
9. Battery Cell Damage Protection: The DJI GO 4 app displays a warning message when a damaged
battery cell is detected.
10. Hibernation Mode: The battery will cut the power supply and switch o after 20 minutes of inactivity
to save power. To prevent over discharging the battery will enter Hibernation mode after six hours of
inactivity if the battery level is less than 10%. In Hibernation mode the battery level indicators do not
illuminate. Charging the battery will wake it from hibernation.
11. Communication: Information pertaining to the battery’s voltage, capacity, and current is transmitted
to the aircraft.
Refer to the Mavic Air Intelligent Flight Battery Safety Guidelines before use. Users take full
responsibility for all operations and usage.
Before carrying Intelligent Flight Batteries on an airline ight, they must be discharged to 30%
or lower. This can be done by flying your Mavic Air outdoors until there is less than 30%
charge left or until the Intelligent Flight Battery no longer turns on.
Detaching the Propellers
Press the propellers down into the mounting plate and rotate them in the unlock direction.
Propeller blades are sharp – handle with care.
Only use original DJI propellers and do not mix propeller types.
Ensure that all propellers are in good condition before each ight. Do not use aged, chipped,
or broken propellers.
Ensure that the propellers and motors are installed rmly and correctly before each ight.
To avoid injury, stand clear of and do not touch propellers or motors when they are spinning.
Place the aircraft in the direction shown in the carrying case during transportation or storage
to avoid damaging the propellers. Do not squeeze or bend the propellers. If propellers
become distorted ight performance will be aected.