11
Remote Controller
1. Ensure the remote controller is fully charged before each ight.
2. If the remote controller is powered on and has NOT been used for 5
minutes, it will sound an alert. After 10 minutes it will automatically power
off. Move the sticks or perform some other action to cancel the alert.
3. Adjust the clamp of the mobile device holder to allow a rm grip on your
mobile device.
4. Ensure the mobile device holder is rmly in place and does not slip.
5. Ensure the antennas of the remote controller are unfolded and adjusted
to the proper position to achieve optimal transmission quality.
6. Repair or replace the remote controller if damaged. A damaged remote
controller antenna will greatly decrease performance.
7. Linking is required if you wish to replace your remote controller or
receiver or add a new remote controller. Refer to the User Manual for
details.
Camera
To avoid possible serious injury and property damage, observe the following
rule:
1. DO NOT block any ventilation holes on the camera as the heat generated
may hurt you and damage the device.
1. Check camera settings before use to make sure you can adjust them to
t your needs.
2. Test the camera by shooting a few test images and check that it is
operating correctly before shooting important pictures or videos.
3. DO NOT remove the Micro SD card from the camera when it is powered on.
4. Photos or videos cannot be transmitted or copied from the camera if the
Intelligent Flight Battery is powered off.
5. Be sure to power off the Intelligent Flight Battery correctly, otherwise your
camera parameters will NOT be saved and any recorded videos may be
damaged. NOTE: Regardless of the reason, DJI will not be responsible
for any failure of an image or video to be recorded or having been
recorded in a way that is not machine readable.
To Next Page
Loading...
Need help?
General