2
©
2018
DJI All Rights Reserved.
EN
Disclaimer
Thank you for purchasing MG Spreading System (abbreviated as “Spreading System”). Read
this disclaimer carefully before using this product. By using this product, you hereby agree to this
disclaimer and signify that you have read it fully. Please use this product in strict accordance with
the manual and be sure to pay attention to the Warning. SZ DJI TECHNOLOGY CO., LTD., and
its afliated companies assume no liability for damage(s) or injuries incurred directly or indirectly
from using, installing or refitting this product improperly, including but not limited to using non-
designated accessories.
DJI
TM
is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as “DJI”) and its afliated
companies. Names of products, brands, etc., appearing in this manual are trademarks or registered
trademarks of their respective owner companies. This product and manual are copyrighted by DJI
with all rights reserved. No part of this product or manual shall be reproduced in any form without
the prior written consent or authorization of DJI.
This disclaimer is produced in various languages. In the event of divergence among different
versions, the Chinese version shall prevail when the product in question is purchased in China, and
English version shall prevail when the product in question is purchased in any other region.
Warning
1. The Spreading System is only compatible with the DJI AGRAS
TM
series aircraft (refer to “Specications”
for details). DO NOT use it with other products or for purposes other than agriculture.
2. The Spreading System is compatible with dry materials of a diameter between 0.5 - 5 mm. DO
NOT use with other materials. Use with other materials will adversely affect operating results and
may damage the Spreading System. All materials must be used in strict accordance with the
instructions for those materials.
3. Internal spread tank load must not exceed 10 kg.
4. Use of a threadlocker is required during the installation process. Ensure that the threadlocker is
totally dry and solid before ight.
5. Ensure that the hopper gate and spinner disk function normally before each use.
6. Operate with caution to avoid injury caused by mechanical parts.
7. When spreading is in progress, maintain a safe distance from the Spreading System to avoid injury.
8. DO NOT use liquids to rinse the Spreading System. Dry compressed air is the recommended
cleaning agent.
Introduction
The MG Spreading System is compatible with the Agras series aircraft. It offers efcient, reliable
and stable spreading operations when used in combination with the Agras series aircraft. Material
delivery rate is precisely controlled by the built-in stirring device and material hopper gate. This can
prevent material blockages and improve operating accuracy and reliability.
Use the DJI MG app to set parameters such as hopper outlet size and spinner disk rotating
speed. These parameters can be adjusted to meet different application requirements. The DJI MG
app provides empty tank warning notifications. The app also provides warning notifications for
abnormalities in rotating speed, temperature, and hopper outlet size. These warning notications
help ensure system safety.
To Next Page
Loading...
Need help?
General
