dji MG - Route Operation Mode; A-B Route Operation Mode; Manual Plus Operation Mode; Manual Operation Mode

© 2018 DJI All Rights Reserved.
5
EN
2. Power on the remote controller, and then power on the aircraft.
3. Enter Operation View in the DJI MG app.
4. To set the hopper outlet size, spinner disk rotating speed, and ying speed, tap the
Spreading
Settings
button
89%
, which is located towards the top of the interface.
Adjust the settings so that they are suitable for the materials you are using, and test for the
desired operating effect.
NOTE: When measuring between 7.5 to 9 kg/ha of spread materials, it is recommended to:
• Adjust the hopper outlet size so that the material delivery rate can be 1 kg/min.
• Adjust the spinner disk rotating speed so that the spreading range can be 4 to 6 meters.
• Set the ying speed to 4 m/s. (Flying speed setting is invalid in Manual Operation Mode)
5. Enter the operation mode required to start spreading for your aircraft. The Spreading System
operation methods vary in different operation modes.
Route Operation Mode
After starting an operation, the aircraft ascends to an altitude of 4 meters and the spinner disk
spins. When the aircraft reaches the route starting point, the hopper gate opens according to
the set value and the aircraft ies along the route and spreads material automatically. Spreading
cannot be started or stopped manually.
The operation resumption function can be used during operation. Once the operation is
paused, the hopper gate closes automatically to stop spreading while the spinner disk is still
spinning. After operation is resumed, the aircraft returns to the breakpoint or projection point and
continues spreading.
A-B Route Operation Mode
After Point A and B are recorded and the aircraft enters A-B Route Operation Mode, the spinner
disk spins. When the aircraft reaches the rst turning point, the hopper gate opens according to
the set value and the aircraft ies along the route and spreads material automatically. Spreading
cannot be started or stopped manually.
The operation resumption function can be used during operation. Once the operation is paused,
the hopper gate closes automatically to stop spreading and the spinner disk stops spinning.
After operation is resumed, the aircraft returns to the breakpoint or projection point and
continues spreading.
Manual Plus Operation Mode
Switch to M+ after the aircraft takes off. Press the
Spray
button (here used as the
Spread
button)
once to start the spinner disk. The hopper gate opens according to the set value and the aircraft
spreads material automatically once it has begun ying.
Manual Operation Mode
Switch to M after the aircraft takes off. Use the
Spread
button on the remote controller to start or
stop spreading.
In all operation modes except Manual Operation Mode:
• When the aircraft ies forward or backward, the hopper gate opens automatically to start
spreading.
• When the aircraft ies left or right, the hopper gate closes automatically to stop spreading
while the spinner disk is still spinning.