dji MG - Usage

4
© 2018 DJI All Rights Reserved.
EN
c. Insert the plugs on the left landing gear leg into the mounting holes on the spread tank.
d. Slide the xing bracket on the right landing gear leg to a position 135 mm below the landing
gear mounting base as shown below, and align the screw holes on the xing bracket with the
n on the right side of the spread tank. Tighten the two M3×12 screws, and insert and tighten
one M3×10 (Plus) screw.
e. Connect the cable to the Reserved Expansion Port 2 (7-pin) on the aircraft body.
Usage
1. Open the cover of the spread tank as shown, add compatible materials, and then close it.
b. Lift the spread tank with the mouth of the tank facing towards the rear of the aircraft.
M3×12 M3×12
M3×10 (Plus)
135 mm
M3
125 mm