The battery can be fully charged in about 3 hours and 30 minutes by a charger with
a maximum charging power of 10 W.
Battery Maintenance
1. If a battery will not be used for 10 days or longer, discharge it to 40%-65% state
of charge (until LED 3 lights up or blinks) for storage.
2. Charge and discharge the battery about every three months to maintain good
conditions of the battery and extend lifetime of the battery. If the battery is stored
after completely drained, it may over-discharge and be damaged.
3. Always store Intelligent Flight Batteries in a well-ventilated place.
4. The battery will enter Hibernation mode if depleted and stored for a long period
of time. Recharge the battery to bring it out of Hibernation mode.
Using for the First Time
Follow the steps below to prepare to use the aircraft and remote controller.
Preparing the Aircraft
Step 1: Remove the gimbal protector and unfold the aircraft arms.
Step 2: Check the battery level of the drone battery, power on the drone, and place
it on a flat ground. Note that the rear of the drone should face towards you.
Watch this video for the more details.
To Next Page
Loading...
