To Next Page

To Previous Page

User Manual

Using with DJI GO app

Intelligent Flight Modes are available in the DJI GO app* when using the DJI Lightbridge 2.

Download the DJI GO App

Search “DJI GO” on the App Store or Google Play and download the app to

your mobile device.

For the best user experience, please use mobile devices with iOS 8.0 (or higher) and Android 4.1.2

(or higher).

*Forincreasedsafety,theightisrestrictedtoaheightof30manddistanceof50mwhennotconnectedor

loggedintotheappduringight,includingDJIGOandallappscompatiblewithDJIaircraft.

Beginner Mode

The N3 will enter Beginner Mode the rst time you use the DJI GO app, which can be canceled

on the “MODE” page. In Beginner Mode, the Max Height and Max Distance are restricted to 30

meters.

Auto Take-off

Use auto take-o to take o your aircraft automatically if the Aircraft Status Indicator is blinking

green. Follow the steps below to use auto take-o:

1. Launch DJI GO app, enter “Camera” view.

2. Ensure the aircraft is in “P” mode.

3. Go through the pre-ight checklist.

4. Tap“ ”, and conrm ight conditions. Slide to conrm and take-o.

5. Aircraft takes o and hovers at 1.2 meters above ground.

Auto-Landing

Use auto-landing to land your aircraft automatically if the Aircraft Status Indicator is blinking green.

Follow the steps below to use auto-landing:

1. Ensure the aircraft is in “P” mode.

2. Check the landing area condition before tapping “ ”, to perform landing.

3. Aircraft lowers the landing gear and proceed to land automatically.

Updating the Home Point

There are two ways for updating the Home Point.

1. Update the Home Point via DJI GO app when using with Lightbridge 2.

2. Quickly ip the F-switch more than three times to update the Home Point when using a non-

DJI receiver.

The aircraft status indicator blinks green to show Home Point is set successfully.

dji N3 User Manual

Other manuals for dji N3