dji N3 - System Modules; LED Module; Installation; Overview

N3
User Manual
©
2016 DJI All Rights Reserved.
7
1. Flight Status Indicator
Indicates the status of the flight control
system.
2. Micro USB Port
Used to congure and upgrade the N3 via DJI
Assistant 2.
1
Ensure all parts are in good condition.
2
Watch video tutorials (http://www.dji.com/n3):
Watch the installation and connection video tutorials for an overview of the installation
process. Then mount the parts to your airframe and connect them properly.
Watch the DJI Assistant 2 video tutorial for a brief introduction on how to configure the
parameters. Then launch the DJI Assistant 2 and congure the parameters.
3
Ensure the motor, remote controller channels and Failsafe settings are correct.
4
Ensure the devices connected to the ight controller are working normally and correctly set in
DJI Assistant 2.
Installation
Overview
Installation Procedure
Read this section carefully and follow the procedures below to install your ight control system,
otherwise the ight control system may not normally work.
LED
1
2
LED Module
The LED Module has an integrated LED Indicator and Micro USB port.
A. The LED is mainly for ight control system status indication during ight (e.g. Flight Mode).
B. In addition, there is a Micro USB port for rmware upgrades via DJI Assistant 2.