EN
RONIN 2
Quick Start Guide
8
©
2017 DJI OSMO All Rights Reserved.
Mechanical & Electrical Characteristics
Weight Including Grip: 14 lb (6.3 kg)
Excluding Grip:11 lb (4.9 kg)
Dimensions Excluding Grip: 350 mm (W) × 416 mm (D) × 530 mm (H)
Including Grip: 630 mm (W) × 416 mm (D) × 720 mm (H)
Input Power Intelligent Battery: 4280 mAh-22.8 V
Working Current Static current: ≈300 mA (@22.8 V)
Dynamic current: ≈500 mA (@22.8 V)
Locked motor current: Max 15 A (@22.8 V)
Operating Frequency 2.4-2.4835 GHz; 5.725-5.850 GHz
Transmitter Power (EIRP) 2.4 GHz
FCC: ≤25 dBm; CE: ≤20 dBm; SRRC: ≤20 dBm
5.8 GHz
FCC: ≤25 dBm; CE: ≤14 dBm; SRRC: ≤14 dBm
Operating Temperature -4° to 122° F (-20° to 50° C)
For more information, read the User Manual:
http://www.dji.com/ronin-2
※This content is subject to change without prior notice.
Remote Controller Operation
A. Press and hold the power button to turn on the remote controller. The status LED will glow solid green,
indicating that it is connected to the gimbal.
B. Sets the control speed for each axis.
C. Toggles through the various operation modes.
D. Toggles the Prole switch to select preset parameters.
E. Turn the Roll Knob to control roll axis movement. Push the Control Joystick up or down to control tilt axis
movement. Push the Control Joystick left or right to control pan axis movement.
The status LED of the remote controller is disconnected from the gimbal when it glows solid red which will
require a re-binding. Enter the Settings page via the built-in touch panel and select “Bind Device.” Within
the duration of 30 seconds, press C1
+
C2, and the Record Button simultaneously on the remote controller
until you hear a continuous beep. The status LED will glow solid green once a successful connection is
established.
+
-
PAN
+-
ROLL
REC
ROLL
MODE
RONIN
POWERED BY
Free
Follow
Recenter
+
-
TILT
PROFILE
Default
User 1
User 2
A
C
E
D
B