dji RS 3 PRO - Mounting the Camera; Supported Cameras and Lenses; Mounting a Camera

DJI RS 3 Pro User Manual
8
©
2022 DJI All Rights Reserved.
Mounting the Camera
Supported Cameras and Lenses
DJI RS 3 Pro has been rigorously tested to support a payload of 4.5 kg. Make sure the combined
weight of the camera, lens, and other accessories are within 4.5 kg. Refer to the ocial DJI website
(https://www.dji.com/support/compatibility) for the most updated Ronin Series Compatibility List.
Mounting a Camera
Make sure to prepare the camera before mounting it to DJI RS 3 Pro. Remove the lens cap and check
that the battery and memory card are inserted in the camera.
Make sure DJI RS 3 Pro is powered o or in sleep mode before mounting the camera. Toggle the tilt
lock and roll lock to the unlocked position and adjust the gimbal position as shown, and then toggle the
two locks to the locked position.
Roll Lock
Tilt Lock
1. Attach the Upper Quick-Release Plate
Attach the upper quick-release plate to the camera by tightening the screw.