dji SPARK REMOTE CONTROLLER C2 - Battery Level and Charging; Checking Battery Level; Charging the Battery

3
EN
1. Flight Mode Switch
2. Function Button
3. Control Sticks
4. Antennas
5. Power Button
6. Mobile Device Clamp
7. Power Port (Micro USB)
8. Flight Pause Button
9. RTH Button
10. Status LED
11. Battery Level LEDs
1
2
3
4
5
6
7
9
14
8
12
13
10
11
15
12. Gimbal Dial
13. Customizable Button
14. Record Button
15. Shutter Button
1
2
3
4
5
6
7
9
14
8
12
13
10
11
15
* Spark's remote controller is currently only compatible with Spark aircraft.
** The remote controller can reach its maximum transmission distance (FCC)
in a wide open area with no electro-magnetic interference and at an altitude
of about 120 meters. The maximum run-time is tested under laboratory
environment, only for your reference.
1. Checking Battery Level and Charging
Checking Battery Level
Press the Power button once to check the current battery level. Press once, then
again and hold to turn on/off the remote controller.
Charging the Battery
It takes approximately 1.5 hours to fully charge the remote controller.
Low High
100~240V
A
A