12 | OPC506(G) man.
SAFETY & OPERATION
REVERSING YOUR OEM BLADES
YOUR CHIPPER IS EQUIPPED WITH DUAL REVERSIBLE CUTTING BLADES
1. Turn the engine key o, remove key and unplug the spark plug.
2. Open large feed chute.
4. Remove the first 4 bolts.
6. Remove the OEM blade, reverse it to the new sharp edge and re-install it. Use only DK2
POWER OEM blades for top performance.
7. Use Loctite on the bolt threads when replacing the bolts.
8. Use the supplied T-handle tool to remove and replace bolts.
9. Wear protective gloves, the blades are very sharp.
10. Remove the paper towels, any paper left in the chipper will be cut up on the next running
operation.
EXAMPLE ON THE NEXT PAGE
3. NOTE: Before removing the bolts that mount the blades, place paper towels in the area
opening between the drum and the drum housing. This will prevent bolts from dropping into
the drum housing.
5. NOTE: Before removing the last bolt, be sure to support the blade from sliding down the
drum. More paper towels or a shop towel does a good job.
ENGLISH
To Next Page
Loading...
