14 | OPC506(G) man.
SAFETY & OPERATION
SAFE PRACTICES & GENERAL INFORMATION
BEFORE TURNING THE KEY AND PULL STARTING ENGINE
• Clear area of all people and property that could be damaged. Think safety.
• Chips are flying projectiles and can cause injury.
• Check both chutes and make sure they are closed and locked.
• Wear safety glasses, hearing protection, and gloves.
IF YOUR UNIT WILL NOT START
1. Check all white wire connections.
2. Check key switch is turn to the ON - right hand position.
3. Also unplug the white connector from the key switch and try it.
SAFE PRACTICES
• Do not wear loose fitting clothes that could get stuck in the chipper.
• Only chip wood, no metal or plastic.
• Children should not run this equipment.
• Stay alert of your surroundings and persons that could appear in the chipping projectile path
while operating.
• Feed large diameter trees slowly into the cutting drum to regain cutting RPM between cuts.
ENGLISH
To Next Page
Loading...
