To Next PageTo Next Page
Need help?Do you have a question about the DLS SuperNaturalSound Reference 100 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Amplifier Class | AB |
| Output Power (RMS) @ 4 Ohms | 100 W x 2 |
| Output Power (RMS) @ 2 Ohms | 150 W x 2 |
| Output Power (RMS) @ 4 Ohms Bridged | 300 W x 1 |
| Damping factor | >200 |
| S/N ratio, A-weighted | >100 dB |
| Input impedance | 22 kOhm |
| Recommended power cable | 4 AWG |
| Fuses | 2 x 25 A |
| THD | < 0.05 % |
| Weight | 3.5 kg |
| High pass filter | 50 Hz - 500 Hz |
| Low pass filter | 50 Hz - 500 Hz |
Guidance on selecting appropriate DC power cable size and fuse for amplifier.
Connecting subwoofers in mono bridge mode for increased power output.
Information on amplifier protection circuits and their indicators.
Troubleshooting steps when the amplifier does not power on.
Troubleshooting overheating issues causing the amplifier to shut down.
Identifying and resolving noise issues like engine whine or constant hum.
Diagram for connecting a subwoofer in mono bridge mode.
Diagram for multimode setup with front stereo and mono subwoofer.
