Freestanding
Installation
1. Put the product upside
down on a soft cotton
cloth or carpet.
2. Fix the feet to the base
of the heater using the
screws provided.
ºLine up the holes in
the base with the holes
(1, 2, 3, 4) in the feet,
put the screws through
the holes, and tighten
with a screwdriver
(not supplied).
• To prevent a hazard, the manufacturer, a service representative, or someone else
similarly qualified must replace the supply cord if it is damaged.
• Avoid the use of an extension cord, as this may overheat and cause a fire risk.
• Never place the heater where it may fall into a bathtub or any other body of water.
• Do not use the heater in the immediate area of a bath, shower, or swimming pool.
• Children younger than 3 years should be kept away unless continuously
supervised.
• Children aged 3 to 8 years old should only switch the appliance on or off (provided
that it is installed in its normal operating position) and have been given supervision
or instruction concerning the use of the appliance.
• Children under 8 years old should not plug in, regulate, clean, or perform
maintenance on the appliance.
• Children 8 years of age and older should only use this appliance if they have been
given supervision and instructions on how to use it safely.
Installation Instructions
Before installing, check that all parts are complete and the product is intact.
If you want to use the electric heater freestanding, please fit it with the feet provided
with the heater, following the instructions opposite. Make sure the heater is placed on
a level, stable, and clean surface.
2 2
4 4
1 1
3 3
To Next Page
Loading...