DMG Icon - Product Information; Side Effects and Interaction; Composition

21
12. Light-cure Icon-Infiltrant for 40 s.
13.
Screw anew Smooth Surface-Tip onto the Icon-Infil-
trant syringe, repeat the application, and allow to set
for 1 minute. Remove excess material with acot-
ton wad and dental floss, and light-cure for amin-
imum of 40 s.
14.
Remove the rubber dam. Use polishing cups (or sim-
ilar) for the surface finish.
Side effects
• In some cases, contact allergies with similar compos-
ite products have been reported.
•
Contact of Icon-Etch with the oral mucosa causes
awhite surface coloration. This will subside after
afew days.
Interaction
Polymerization inhibiting substances such as products
containing eugenol (e. g. temporary cements) must not
be used in combination with this material.
Composition
• Icon-Etch: Hydrochloric acid, pyrogenic silicic acid,
surface-active substances
9. Apply an ample amount of Icon-Infiltrant onto the
etched surface by turning the shaft.
10. Allow Icon-Infiltrant to set for 3 minutes. The Infil-
trant will be activated by slightly moving the appli-
cator. Add material if necessary.
▸
In case of deeper and larger defects the esthet-
ic result can be improved by extending the expo-
sure time up to 6 minutes.
11. Remove excess material with acotton wad and den-
tal floss.