714/715 Installation Guide | Digital Monitoring Products 2
Wire the Module
Connect the 714 to the LX-Bus
To wire the 714, join the red, yellow, green,
and black wires to a 4‑wire harness and
connect it to the LX‑Bus.
Connect the 714 to the Keypad Bus
1. Connect the red, yellow, green, and
black wires to panel Terminals 7, 8, 9,
and 10 respectively.
2. Observe polarity and wire zones 1‑4.
3. Install the included 1K Ohm EOL
resistors.
Connect the 715 to the LX-Bus
To wire the 715, connect the red wire to panel Terminal 11 (Smoke power terminal). This allows Sensor Reset to
drop power to the module and devices connected to its zones. Join the yellow, green, and black wires to a 4‑wire
harness and connect it to the LX‑Bus.
Connect the 715 to the Keypad Bus
1. Connect the red wire to panel Terminal 11 (Smoke power terminal). This allows Sensor Reset to drop power
to the module and devices connected to its zones. Alternately, connect red to a regulated, power limited
power supply listed for Fire Protective Signaling through a Model 716 relay. Use the Sensor Reset Output
programming to drop power to the 715 module.
2. Connect the yellow, green, and black wires to panel Terminals 8, 9, and 10 respectively.
3. Observe polarity and wire zones 1‑4.
4. Install the included 3.3K Ohm EOL resistors.
3
714
Module
Black
Green
Yellow
Red
714 Module:
Connect Red to LX-Bus Wire or Panel Terminal 7
715 Module:
Connect Red to Panel Terminal 11 or a
regulated, power limited power supply listed for
Fire Protective Signaling through a Model 716 relay
+
–
+
–
+
–
+
–
To Keypad Bus or LX-Bus
0
1
2
3
4
5
6
7
8
9
S2
0
1
2
3
4
5
6
7
8
9
S1
TENS ONES
White/Brown: Zone 1
White/Red: Zone 2
White/Orange: Zone 3
White/Yellow: Zone 4
A
B
A
B
Figure 3: Module Wiring
SPECIFICATIONS 714 MODULE 715 MODULE
Normal Operating Range 650‑2100 Ohms 1200‑6000 Ohms
Zone Resistors 1k Ohm EOL 3.3k Ohm EOL
Max Line Impedence 100 Ohms 100 Ohms
Zone Supervision All Zones All Zones
Table 1: 714 and 715 Modules Specifications
To Next Page
Loading...