DMTech FP9000L-2 - Page 4

Instructions for installation, setup and operation - FP9000L-2/4/6/8
Page 4 of 16
 Electrical characteristics
3А/125V AC,
3A/30V DC
 Independent relay output in case of failure:
 Quantity
1
 Type
potentional-free,
switching
NC / NO
 Electrical characteristics
3А/125V AC,
3A/30V DC
 Delay outputs:
 Time delay of switching outputs
0 ÷ 7 minutes
POWER SUPPLY
 Mains power
 Voltage
(187-252)V AC
 Frequency
50/60 Hz
 Maximum power to mains power
38W / AC
 Battery power
 Battery quantity
2
 Type of the battery
Lead, gel
 Battery rated voltage
12V DC
 Reted power C20
1.3Ah, 4.5Ah, 5 Ah
 Charger voltage
27,6 VDC
temperature
compensated
Consumption of battery power in standby mode
 Configuration with 2 lines
< 40 mA to 24 VDC
 Configuration with 4 lines
< 50 mA to 24 VDC
 Configuration with 6 lines
< 60 mA to 24 VDC
 Configuration with 8 lines
< 70 mA to 24 VDC
Time needed in security mode when mains power supply is down with battery 12V/ 5Ah
 Configuration with 2 lines
120h
 Configuration with 4 lines
90h
 Configuration with 6 lines
80h
 Configuration with 8 lines
72h
Time needed in security mode when mains power supply is down with battery
12V/1.3Ah
 Configuration with 2 lines
32h
Executive devicess powering
 Voltage
(19-28)V DC
 Maximal current (including the controllable
outputs current)
1А
Fuses
 Mains power 230V AC
4,0 A fusible
 Battery power
4,0 А fusible
 Powering external devices
1,85 А automatic
 Controllable outputs
1,1 А automatic
Functional characteristics
 Control of the lines and controllable outputs for fault conditions (short circuit and