DNA MA3 - Settings and Specifications; Audio Settings Menu; General Unit Specifications; Tuner and USB Player Specs

8
Settings & Specications
Additional Settings
Setup Menu
Press and hold the MODE button for more than 3 seconds to access the set
up menu. Press the MODE button momentarily to select between the menu
functions and push the volume or to adjust the following functions.
Bass
Press the mode button until BAS appears.
Push the volume or to adjust. (-7 minimum / +7 maximum)
Treble
Press the mode button until TRE appears.
Push the volume or to adjust. (-7 minimum / +7 maximum)
Balance
Press the mode button until BAL appears.
Push the volume or to adjust. (-7 minimum / +7 maximum)
Specications
General
Power supply requirements: DC 14.4V, Negative Ground
Load impedance: 4-8 ohms / channel
Maximum output power: 40W x 4 (CH)
Chassis dimensions: 76.5mm (diameter) x 58mm (depth)
Current drain: 5A
FM Tuner
Tuning range: 87.5MHz - 108MHz
AM Tuner
Tuning range: 522kHz - 1620kHz
Usable sensitivity: <5uV
USB Music Player
Signal to Noise Ratio: 55dB
Frequency Response: 20Hz - 20KHz
A/D Conversion Filter: 16 BIT