6
EU-CSD0923001–0923002
en
2. SAFETY INSTRUCTIONS FOR A
SCREWDRIVER OPERATION
Hold the power tool by the insulated
surfaces of the handle, as the tool may
touch hidden wiring during operation. If
the accessory comes into contact with a
live wire, the exposed metal parts of the
power tool may become live and cause
an electric shock to the operator.
3. SAFETY RECOMMENDATIONS
FOR A SCREWDRIVER OPERATION
Protect the charger from rain and mois-
ture. Water entering the charger increas-
es the risk of electric shock.
Before use, check the charger, cable
and plug for damage. Do not use a char-
ger that is found to be damaged. Do not
open the charger by yourself, but entrust
only using original spare parts. Damaged
chargers, cables and plugs increase the
risk of electric shock.
Do not leave the charger turned on.
The power tool has an autonomous pow-
er source (accumulator) and is always
ready for work. Avoid accidentally press-
ing the switch button — this can lead to
personal injury or other damage.
Do not spin the power tool, there is a
danger of short circuit, which can cause
Protect the power tool from high tem-
may be a risk of explosion.
In case of damage and improper opera-
tion, gas may be released from the accu-
mulator. In this case stop using the power
tool immediately. Provide access to fresh
air. Gases can cause irritation of the re-
spiratory tract, if complaints occur, con-
sult a doctor.
Use appropriate metal detectors to lo-
cate hidden supply systems and/or con-
tact the appropriate utility company for
assistance. Contact with electrical wiring
-
age to the gas pipeline can result in an
can result in material damage.
When tightening/unscrewing wood-
screws/screws, high reactive moments
may occur for a short time.
in clamping devices or vices, so it is held
more securely than when holding it by
hand.
Do not put down the power tool until the
accessory has come to a complete stop.
4. CONVENTIONAL SINGS
General caution sign (risk to
people, explained by an addi-
tional sign or text)
DC Direct current
Class of protection against
electric shock III
IP
Degree of protection against
dust and water
n
0
Idle speed
21
Symbol of the possibility of
secondary treatment
Mark of compliance with tech-
nical regulations (Ukraine)
that the electric tool meets
the basic requirements of EU
directives and harmonized
standards of the European
Union
The unique sign of circulation
of products on the market of
the member states of the Eur-
asian Economic Union (EAEU)
Separate collection of electri-
cal and electronic equipment
(to prevent possible damage
to the environment, it is nec-
essary to separate electri-
cal and electronic equipment
from other waste and dispose
of it in the safest way)
To Next Page
Loading...