EU-CSD0923001–0923002
en
in red: the accumulator of the power tool
is in the process of charging. Wait for full
charging.
The charge indicator lights up in green:
the accumulator is fully charged and the
power tool is ready for use.
After charging, it is recommended to al-
low the power tool to cool down for
some time (about 15 minutes).
The voltage and current parameters for
charging the power supply must corre-
-
Approximate charging time of the power
tool is 60 minutes.
Approximate operating time of the pow-
er tool after full charging is 40 minutes.
WARNING!
The accumulator charging time de-
pends on its capacity and the char-
ger current and may differ from the
specified range.
After charging is complete, discon-
nect the USB cable from the power
tool connector.
Do not use power tools during
charging.
9. WORKING WITH POWER
TOOLS
Before each use of the power tool, you
should check the operation of the switch-
es (4, 5) (Fig. 1), their operation should be
clear, without jamming. Check the oper-
ation of the power tool at idle speed by
performing a test switch-on.
Turning on/off the power tool
To turn on the power tool, press and hold
the screwing switch (1) or the unscrewing
switch (2) (Fig. 4).
-
ically turn on and light up during rotation.
WARNING!
It is forbidden to simultaneously
press and hold switches (1) and (2)
(Fig. 4).
To turn off the power tool, release the
switch (1) or (2) (Fig. 4).
After turning off the power tool, the
will stop as well.
The power tool is equipped with an au-
tomatic chuck lock. When the chuck is
locked (switches do not pressed), the
power tool can be used as a standard
screwdriver. This is convenient when
higher torque is required.
Instructions for working with power
tools
Bring up and install the bit at a right angle
into the slot of the fastener.
Click on the required switch (screw/un-
screw).
When screwing/unscrewing, do not ex-
ert excessive pressure on the power
tool. If the power of the power tool is not
enough to perform the work and the ro-
tation frequency of the chuck noticeably
decreases, then turn off the power tool
and work in manual mode (applying the
operator's muscle power).
WARNING!
In the event of an abnormal situa-
tion, such as a sudden increase in
temperature, if there is a burning
smell, smoke or flame, immediately
turn off the power tool/disconnect
from the charger.
10. MAINTENANCE
Regularly wipe the body of the power
tool with a soft cloth. Do not use solvents
such as gasoline, alcohol, water-ammo-
nia solution, etc., as they can damage the
plastic parts of the power tool. Make sure
that moisture does not get into the open-
ings on the body of the power tool.
Unauthorized intervention into the inter-
nal structure will result in termination of
warranty, possible electric shock and in-
jury.
To Next Page
Loading...