You can select Auto, Wired only or Wireless only.
If you select Auto, it will detect automatically for either wired connection or wireless connection.
If you select Wired Only, it will only connect through Wired connection.
If you select Wireless Only, it will only connect through Wireless Wi-Fi connection.
Configuring the radio to only use a wired Ethernet connection
Selecting ‘Wired Only’ will cause the radio to reboot and then only use its Ethernet connection to communicate with the
network. The radio will also disable its wireless network capabilities.
Configuring the radio to only use a Wi-Fi connection
Selecting the ‘Wireless Only ‘ option from the ‘ Wired/Wireless’ menu will cause the radio to reboot and then only use its
Wi-Fi connection to communicate with the network. The radio will also disable its Ethernet connection.
Configuring the radio to use either an Ethernet or a wireless connection Selecting the ‘Auto’ option from the
‘Wired/Wireless’ menu will cause the radio to reboot and then attempt to establish and then attempt to establish an
Ethernet connection, if it is available, to communicate with the network. Otherwise, the radio will attempt to establish a
Wi-Fi connection to the network.
Once the radio has established a certain type of connection to the network, then this type of connection will remain in use
while the radio is on.
<Scan for network>
You will be guided to how to set the wireless application with the wizards. Please refer to Step 1 above for details.
<Enter network>
You can input the network name by using this feature
<View Config>
To view the current configuration of the network
<Edit config>
You can set the DHCP auto ON or OFF and if this DHCP ON is set, this device will auto set and get the IP address and
gateway DNS settings automatically. If you set the DHCP off, you will be asked to input these address or number manually
for the network configuration.
TIPS: Please set DHCP ON as default and you can get the network connection automatically.
<Signal Warning>
It allows you to choose whether or not the Internet radio displays a warning message when its network signal strength is low.
You can enable this feature by selecting ‘Signal Warning
Other options under Setting
<Version>
Displays the versions number of the various part of software on you Internet radio. You may be requested for these information
when you need assistance on technical support.
<Upgrade Firmware >
Use this option to download new firmware for the radio from the Reciva portal on the internet. If there is new firmware
available, the radio will pop out a message and ask if you want to download it or not. At this stage, you can still return to the
previous menu by pressing the Back button.
A firmware upgrade may take several minutes, so do no switch off the power to
the radio until the operation is complete otherwise the radio may become permanently damaged.
To Next Page
Loading...