Vehicles Equipped With Keyless Enter-N-Go
1. Without pushing the brake pedal, push the ENGINE
START/STOP button and cycle the ignition to the
ON/RUN position (Do not start the engine.)
2. Fully push the accelerator pedal, slowly, three times
within 10 seconds.
3. Cycle the ignition to the OFF/LOCK position.
Vehicles Not Equipped With Keyless Enter-N-Go
1. Turn the ignition switch to the ON/RUN position (do
not start the engine).
2. Fully push the accelerator pedal, slowly, three times
within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
Using The DID Menu
Vehicles Equipped With Passive Entry
• Without pushing the brake pedal, push the ENGINE
START/STOP button and cycle the ignition to the
ON/RUN position (Do not start the engine.)
• Push and release the UP
or DOWN arrow
button to scroll through the main menu to “Vehicle
Info.”
• Push and release the RIGHT
arrow button to
access the ”Oil Life” screen.
• Push and hold the RIGHT
arrow button for one
second to reset the gauge and numeric display to
100% for ”Oil Life.”
• Push and release the UP
or DOWN arrow
button to exit the DID screen.
354 UNDERSTANDING YOUR INSTRUMENT PANEL
To Next Page
Loading...
Need help?
General
