16 GETTING TO KNOW YOUR INSTRUMENT PANEL
Diagnostics — If Equipped
This feature allows the driver to view engine and
emission vehicle faults.
Push OK to have the most recent fault code
sent.
There is a delay when the next diagnostic code
is requested during which the following
message is displayed:
“Checking System for Diagnostic Codes.”
Driver must push the OK button again to see the
next Pcode otherwise current message remains
displayed.
Driver exits when they cycle to another
submenu (up or down).
Faults are displayed from newest to the oldest.
If the menu is exited before the end of codes is
reached - when the driver re-enters the list will
be restarted from the beginning.
When no codes are present or the last code is
reached = (P0000) and this message is
displayed:
“No or End of Diagnostic Codes.”
Speed Warning — If Equipped
Push and release the up or down arrow
button until the Speed Warning Menu icon/title is
displayed in the instrument cluster display. Push
and release OK to enter speed warning. Use the
up or down arrow button to select a desired
speed, then push and release OK to set the speed.
The white passive speed limiter telltale will light up
with a notification text message (Speed Warning
Set to XX), followed by the selected unit. When the
set speed is exceeded, a continuous chime will
sound until the speed is no longer exceeded. The
white passive speed limiter telltale will turn yellow
and will flash, and a pop-up message of “Speed
Warning Exceeded” will display.
NOTE:
You can turn the Speed Warning off by using the
up or down arrows to scroll through speed
list and select OFF at the bottom of the list.
TRANSBRAKE™ (TRACK USE ONLY) —
I
F EQUIPPED
TransBrake™ is specifically designed for the drag
strip by holding the vehicle stationary to achieve
maximum power and torque at launch. This is done
by engaging an additional transmission clutch.
Torque Reserve is automatically enabled while
using TransBrake™, and offers a unique exhaust
note. The Torque Reserve feature maintains
engine airflow to provide faster engine torque
response and improve vehicle acceleration. This
feature is intended for track use only, where
consistent quarter mile and zero to sixty times are
desired. The system is not intended to compensate
for lack of driver experience or familiarity with the
track. Use of this feature in low traction (cold, wet,
gravel, etc.) conditions may result in excess wheel
slip at launch.
NOTE:
TransBrake™ feature will only hold the vehicle
stationary for up to 15 seconds once the brake
pedal is released. The Torque Reserve feature is
limited to 15 seconds after the engine speed
reaches 950 RPM.
22_LALD_S_SU_EN_USC_t.book Page 16
To Next Page
Loading...
