MULTIMEDIA 51
VALET MODE
Valet Mode Activation
To enter Valet Mode, press the Valet button on the
touchscreen and a pop-up screen will ask you if
you would like to enter Valet Mode. After selecting
“Yes”, you will be asked to enter a four-digit PIN.
The PIN is not set, so you are free to select any
four-digit numeric combination that will be easy to
remember.
While in Valet Mode, the following vehicle
configurations are set and locked to prevent
unauthorized modification:
Engine limited to the lowest power output state.
On automatic transmissions, transmission
up-shifts earlier than normal.
Traction, Steering, and Suspension are set to
their Street settings.
Steering wheel paddle shifters are disabled.
The Drive Modes interface is not available.
Pressing the SRT button on the touchscreen will
display the unlock keypad.
The ESC Off button is disabled.
The Launch Control button is disabled.
Valet Mode Deactivation PIN
The Valet Mode Deactivation key pad will then
prompt you for your four-digit PIN. Enter your PIN,
and press the GO button on the touchscreen. Your
vehicle will return to the default state whenever
exiting Valet Mode.
NOTE:
If your four-digit PIN is lost or forgotten, the vehicle
will exit Valet Mode after a battery disconnect for
approximately five minutes. Reconnect the battery
and place the ignition in the ON/RUN position; the
vehicle will be in Auto Mode.
5
22_LALD_S_SU_EN_USC_t.book Page 51
To Next Page
Loading...
