MULTIMEDIA 49
Shift Light
Shift Light
To actuate the Shift Light feature, press the Shift
Light button on the touchscreen, and then press
the Shift Light On button on the touchscreen.
Activation is shown on the instrument cluster
display. Pressing the Shift Light RPM Set-Up button
on the touchscreen will take you to the Shift Light
RPM Set-Up screen.
NOTE:
The Shift Light feature is only available on Scat
Pack Widebody and SRT Models.
The only time the Shift Light comes on is when
the shifter is placed into the M (manual shifting)
position. You may use the shifter +/-, or paddle
shifters, to shift while in the M position.
Shift Light RPM Set-Up
The Shift Light RPM Set-Up allows you to set the
shift light to actuate for gears 1, 2, 3, 4, and 5-8.
By pressing and releasing the Up/Down Arrow
buttons on the touchscreen above and below each
listed gear, the RPM values will change in
increments of 250 RPM. Pressing and holding the
arrows will change the RPM values in increments
of 500 RPM, ranging from 2000–6000 RPM (6.2L)
and 2000–6250 RPM (6.4L and 6.2L HO). The
Shift Light Set-Up screen may only be accessed if
the feature is enabled. Press the Reset to Factory
Default button on the touchscreen to change back
to factory settings, or press the Shift Light Off
button on the touchscreen to turn the system off
completely.
5
22_LALD_S_SU_EN_USC_t.book Page 49
To Next Page
Loading...
