ing torque almost instantly once a stick/slip
event is observed, allowing the vehicle to con-
tinue launching without the need for the driver
to lift off of the throttle.
SRT Power Chiller™
When the vehicle enters DRAG mode, refriger-
ant from the AC system is redirected from in-
cabin air conditioning to the air cooler coolant
circuit. The cabin air conditioning will not func-
tion in this mode.
When ambient temperature is above 55° F, this
system supplements external cooling on the
intake manifold / supercharger and can bring air
cooler coolant temperature below ambient.
NOTE:
• This may bring the charge air temperature
down by up to 45° F (25° C). This does not
function under 55° F ambient.
• Do not use alternative refrigerants.
MAINTENANCE AND STORAGE
Clean Engine Air Filter
When Do I Clean My Engine Air Filter?
• The scheduled air filter cleaning is
30,000 miles, or if in a dusty environment
the engine air filter should be checked peri-
odically to ensure optimal air flow .
• Cleaning your engine air filter with the rec-
ommended Mopar Performance Air Filter
Service Kit P5153376 is not required if you
can still see the wire screen on the entire air
filter regardless of how dirty it may appear . If
you have not experienced a decrease in en-
gine performance, chances are your air filter
is fine and does not need to be cleaned.
When the screen is no longer visible some
place on the air filter , it’ s time to clean your
air filter .
1. Apply Mopar Air Filter Cleaner:
• Spray your air filter with the recom-
mended Mopar air filter cleaner liberally
and let it sit for at least 10 minutes to
loosen the dirt before rinsing.
NOTE:
Do not allow the cleaner to dry on the filter .
2. Rinse Your Air Filter:
• Rinse off your air filter with cool low-
pressure water applied to the clean side
out in order to flush the dirt out of the
filter. Continue to rinse the filter until all
traces of cleaner are gone. It may be
necessary to repeat steps 1 and 2 if the
air filter isn’t completely clean.
3. Dry Your Air Filter:
• After rinsing your filter , gently shake off
the excess water and only allow filter to
dry naturally. Do not apply oil until the air
filter is completely dry.
NOTE:
Do not use forced air pressure as it may de-
stroy the filtering capabilities of the filter’s
microfibers and also void its warranty.
FEATURES OVERVIEW
22
To Next Page
Loading...
