EasyManua.ls Logo

Dodge Challenger SRT - Post-Run Checks

Dodge Challenger SRT
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
b. Adjust throttle to target launch engine
speed between idle - 2350 RPM.
TransBrake Release/Launch
a. V ehicle launches once the last paddle
shifter is released.
NOTE:
If the engine speed rises above 2350 RPM
the TransBrake feature will cancel.
POST-RUN CHECKS
Between Run Checks
Check Tire Condition
One important issue often overlooked is proper
care of the tires. The following is a short list of
suggestions for checking tire condition and tire
care.
1. Check front and rear tire pressure.
Front Tires do not exceed maximum tire
inflation rating.
Rear Tires depending on the outside
temperature and track conditions, the op-
erating pressure recommendation is 18-
24 psi hot.
2. Check the tread depth to be at a safe level.
3. Check for uneven tire wear . Uneven tire wear
could be a result of one or more of the
following:
Uneven tire pressure.
Low tire pressure.
High tire pressure.
Other issue.
Wheel Lug Nut Torque
Proper lug nut torque is very important. To
ensure that the wheel is properly mounted to the
vehicle use a calibrated torque wrench.
Torque Specifications
Lug Nut
Torque Spec
**Lug Nut
Size
Lug Nut
Socket Size
111 Ft-Lbs
(150 N·m)
M14x1.50 22mm
**Use only authorized dealer recommended lug
nuts and clean or remove any dirt or oil before
tightening.
Inspect the wheel mounting surface prior to
mounting the tire and remove any corrosion or
loose particles.
Tighten the lug nuts in a star pattern until each nut
has attained proper torque, verified twice each.
WARNING!
DO NOT tighten the lug nuts fully until the
vehicle has been lowered. Failure to follow
this warning may result in personal injury.
Torque Pattern
27
TRACK USAGE GUIDELINES

Related product manuals