Fluids
Between runs check the following fluid levels:
• Engine oil level.
• Engine coolant level.
• Brake fluid level.
Activate After Run Cooler
After making a pass down the drag strip, this
feature helps cool the car after the engine has
been shut down. The radiator fan and low tem-
perature radiator coolant pump remain on after
shut down for a period up to five minutes, or
until target temperature is reached.
The After-Run Cooling is activated.
A graph in the radio can show the air cooler
coolant temperature in real time while the vehi-
cle's ignition button is in the RUN position with
engine off.
NOTE:
You can only view temperatures with the Key-
less Go ignition in the RUN position and the
engine off.
Check For Hood Scoop Debris
Any debris moving through the air can be col-
lected in the hood scoop, make sure hood scoop
opening is free of debris. This can defeat the
purpose of a scoop, by blocking air from enter -
ing the scoop inlet.
Log Run Data
You can learn much about optimizing your car’s
performance and consistency at a test and tune
session. Use this opportunity to carefully moni-
tor and record vehicle, track and temperature
conditions after each pass prior to staging and
immediately after each run.
CHECKS BEFORE LEAVING THE TRACK
Before returning to the street, check the follow-
ing items:
• Check tire condition, refer to Check Tire Con-
dition.
• Return rear tires to recommended street
pressures (32 psi cold).
• Swap front tires if Demon front runner
wheels were previously installed.
• Lug nut torque: 111 Ft-Lbs (150 N-m).
NOTE:
Refer to page 27 for step-by-step instructions.
• Fluids
– Engine oil level.
– Engine coolant level.
– Brake fluid level.
Hood Scoop Opening
TRACK USAGE GUIDELINES
28
To Next Page
Loading...
