c. Press and hold the “OK” button on the
steering wheel to activate “Line Lock”.
d. While still holding down the “OK” but-
ton, fully release the brake pedal and
apply the gas pedal to begin the burnout.
• Front brakes remain engaged.
• Feature is exited when either the gas
pedal is lifted, the brake pedal is
pressed, the “OK” button is released, or
the max number of tire revolutions is
attained.
4. TransBrake Launch
• Initial Conditions
a. Odometer greater than 500 miles
(805 kilometers).
b. V ehicle must have Drag mode enabled.
c. Engine is running.
d. V ehicle speed is at 0 mph (0 km/h).
e. Steering wheel is straight.
f. V ehicle is in “DRIVE” in 1st gear.
g. Radiator coolant temp is less than
250° F (121° C).
h. Line Lock/Launch Control and Cruise
Control are not engaged.
i. All doors are closed.
j. Parking brake is not set.
k. V ehicle is on level ground.
• Staging The Car
a. At or near Pre-Staging, pull and hold
both paddle shifters back simultane-
ously.
b. Push and hold the brake pedal firmly
with left foot.
c. Slowly apply steady throttle to a pre-
staging engine speed (between 1500-
2350 RPM).
NOTE:
Torque Reserve will be activated at
950 RPM: as a result engine vibration and
exhaust tone will change noticeably.
d. Slightly release brake pressure to roll up
to the stage lights while maintaining
throttle and engine speed.
e. Stop at the full stage light and ensure
vehicle speed is 0 mph (0 km/h).
f. Release one shift paddle at or above
1500 RPM with zero wheel speed.
g. Remove foot from brake pedal.
h. TransBrake is fully engaged/locked when
brake pedal is released and reaches the
upstop.
NOTE:
The Electronic Stability Control (ESC) system
holds brake pressure, and the transmission
locks to hold driveline torque.
• TransBrake Engaged/Locked
a. Remove foot from brake pedal.
NOTE:
The Electronic Stability Control (ESC) sys-
tem holds brake pressure, and the trans-
mission locks to hold driveline torque.
TRACK USAGE GUIDELINES
26
To Next Page
Loading...
