2. Perform one of the following methods to lock the
vehicle:
• Push LOCK
button on the interior power door
lock switch with the driver and/or passenger
door open.
• Push the LOCK
button on the exterior Passive
Entry Door Handle with a valid RKE Key Fob
available in the same exterior zone (refer to ⬙Key-
less Enter-N-Go — Passive Entry⬙ in ⬙Things To
Know Before Starting Your Vehicle⬙ for further
information).
• Push the LOCK
button on the RKE Key Fob.
3. If any doors are open, close them.
To Disarm The System
The Vehicle Security Alarm can be disarmed using any of
the following methods:
• Push the UNLOCK button on the RKE Key Fob.
• Grasp the Passive Entry Unlock Door Handle if
equipped, refer to “Keyless Enter-N-Go — Passive
Entry” in “Things To Know Before Starting Your
Vehicle” for further information.
• Cycle the vehicle ignition system out of the OFF
position.
• For vehicles equipped with Keyless Enter-N-Go —
Ignition, push the Keyless Enter-N-Go — Ignition
START/STOP button (requires at least one valid RKE
Key Fob in the vehicle).
• For vehicles not equipped with Keyless Enter-N-Go
— Ignition, insert a valid key into the ignition switch
and turn the key to the ON position.
NOTE:
• The driver’s door key cylinder and the passive entry
trunk unlock button cannot arm or disarm the Vehicle
Security Alarm.
22 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
To Next Page
Loading...
Need help?
General
