FOUR-WHEEL DRIVE
OPER A TION
Single-Speed Operating Instructions/
Precautions
• This system contains a single-speed
(HI range only) transfer case, which
provides convenient full-time
four-wheel drive. No driver
interaction is required. The Brake
Traction Control (BTC) System, which
combines standard ABS and Traction
Control, provides resistance to any
wheel that is slipping to allow
additional torque transfer to wheels
with traction.
NOTE: This system is not appropriate for
conditions where 4WD LOW range is
recommended. Refer to “Off-Road Driving
Tips” in “Starting and Operating” for
further information.
Electronically Shifted Transfer Case
(Three-Position Switch)
• This is an electronic shift transfer
case and is operated by the 4WD
Control Switch (Transfer Case
Switch), which is located on the
center console.
• This electronically shifted transfer
case provides three mode positions:
• Four-wheel drive automatic range
(4WD AUTO)
• Four-wheel drive low range (4WD
LOW)
• Neutral (NEUTRAL)
• When additional traction is required,
the 4WD LOW position can be used
to lock the front and rear driveshafts
together forcing the front and rear
wheels to rotate at the same speed.
The 4WD LOW position are designed
for loose, slippery road surfaces only.
Driving in the 4WD LOW positions on
dry hard surfaced roads may cause
increased tire wear and damage to
the driveline components.
• When operating your vehicle in 4WD
LOW, the engine speed is
approximately three times that of the
4WD HI position at a given road
speed. Take care not to overspeed
the engine and do not exceed
25 mph (40 km/h).
NOTE: The “SVC 4WD Warning Light”
monitors the electronic shift four-wheel
drive system. If this light remains on after
engine start up or illuminates during
driving, it means that the four-wheel drive
system is not functioning properly and
that service is required.
OFF-ROAD CAP ABILITIES
54
To Next Page
Loading...
