206 IN CASE OF EMERGENCY
NOTE:
Placement for the front and rear jacking locations are
critical. See the following images for proper jacking loca-
tions.
Jacking Locations
3. For the front tire, place the jack on the body flange
just behind the front tire. Do not raise the vehicle until
you are sure the jack is fully engaged.
Front Lifting Point
Front Jacking Location
4. For a rear tire, place the jack in the slot on the rear
tie-down bracket, just forward of the rear tire. Do not
raise the vehicle until you are sure the jack is fully
engaged.
Rear Lifting Point
Rear Jacking Location
5. Raise the vehicle by turning the jack screw clockwise.
Raise the vehicle just enough to remove the flat tire.
6. Remove the lug nuts and wheel.
WARNING!
Raising the vehicle higher than necessary can make the
vehicle less stable. It could slip off the jack and hurt
someone near it. Raise the vehicle only enough to
remove the tire.
22_WD_OM_EN_USC_t.book Page 206
To Next Page
Loading...
